Devive Manager recognise this device as: Now you just have to try to see what type of device you own. If eHome Infrared Receiver or Hauppauge Consumer Infrared Receiver is not in the lists, or there is an exclamation mark or a question mark on the device, perform the following until eHome Infrared Receiver appears correctly in Device manager:. Monday, December 5, 8: Did this solve your problem?

Uploader: Gakree
Date Added: 24 October 2009
File Size: 32.14 Mb
Operating Systems: Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X
Downloads: 42310
Price: Free* [*Free Regsitration Required]

Blasfer am sorry if I am asking too much, because Eventghost is new to me. Sorry this didn’t help. If the pressed buttons continue to repeat, try altering the lighting conditions in the room or moving the location of the remote sensor.

How satisfied are you with this reply? Is this possible using EG?

My suspicion is a bad driver for the Microsoft Remote Control Receiver, but I can find no alternative one. Go to Device Manager.

How does HP install software and gather data? You do not have the required permissions to view the files attached to this post.

Nextpvr with Hauppauge Q: IR blaster?

Example of a TV tuner system with extender – controller on extender. Windows Update is not always accurate. It previously wored stuck to the front of the STB. Originally Posted by dued ok then i’ll try that – my wintv pvr usb2 is recognized ehoem and sage has been running smoothly, so installing your software and net framework 3.


However, the supplied remote control only has limited function for this purpose. I believe It is more of a MCE remote. I suggest updating the IR blaster driver or firmware from HP site manually.

IR Blaster or ehome tranceiver not working to change channels in WMC.

I setup my dad’s awhile back and I can tell you there is a setting that will work. Originally Posted by dued. Bkaster Posted by dued I downloaded the two IR drivers that aredescribed at the forum link you gave below, but I am not sure now what to do. Find all posts by StephaneM. Other remote controls and computers within range can also cause or issue.

Wednesday, December 7, 6: You can follow the question or vote as helpful, but you cannot reply to this thread.

ehome IR Blaster probems in WMC

If you have replaced a TV tuner card with another type and cannot get the remote to work, the controller might have been on the tuner. Thanks for your feedback, it helps us improve the site. You can help protect yourself from scammers by verifying that the contact is a Microsoft Agent or Microsoft Employee and that the phone number is an official Microsoft global customer service number. Click Start egome, right-click Computerand then select Properties. The is something on the DISH on how to set it back to bkaster default.

You can try with another remote to send the event – one that will only send 1 IR code – or check that the IR emitter is well connected on blaxter back of the tranceiver port 1 or 2, does not matterand also check the positioning of the IR eye on the STB.


So, you click on the desired button on your remote, you should see a new event on the left window, starting by “MceRemote.

Once everything is set up and working the way you want, do you want to put the STB remote into storage and use only the blaeter This hardware all worked find in Vista, but won’t in Windows 7.

If the issue persists, as a blatser, you can connect another receiver into the IR IN port at back of the computer. If the light appears, then the problem is probably in the software that is using the remote sensor most likely the Media Center software.

The ends of the blaster cables can be connected to IR receivers built into TV or satellite set-top boxes. An IR controller – electronics that interpret the signal and communicate to Windows. Windows 7 IT Pro.